Pavers per square foot
| Paver | Per sq ft, ⅛ in joints | Per 100 sq ft |
|---|---|---|
| 4 × 8 in | 4.3 | 430 |
| 6 × 6 in | 3.84 | 384 |
| 6 × 9 in | 2.58 | 258 |
| 12 × 12 in | 0.98 | 98 |
| 16 × 16 in | 0.55 | 56 |
| 24 × 24 in | 0.25 | 25 |
Before any extra for cuts. Many pavers are made a little under their nominal size, so with the joint they lay at the nominal size: check the actual size on the label or the maker’s sheet.
The formula
The base runs 6 in past every edge, as Belgard digs it, and is ordered loose: Quikrete’s patio guide tamps about 5 in of gravel to 4. The gravel calculator works out a base of any shape and stone, and the paver patio material list puts the pavers, edge restraint, base and sand for one patio on a single shopping list.
What goes under the pavers
From the bottom up: compacted soil, a geotextile where the soil is soft, the aggregate base compacted in lifts of 2 to 4 in, the 1 in bed of concrete sand, then the pavers, with an edge restraint around them set on the base. The pavers are compacted into the sand and the joints filled with sand. Dig the base, the sand and the paver’s thickness below the finished surface, and slope it at least 2% away from the house so water runs off.
Questions people ask
How many 4 × 8 pavers in a square foot?
With ⅛ in joints, 4.3: each paver takes up 4⅛ × 8⅛ in. Laid tight with no joint, 4.5. So 100 sq ft takes 430 before the extra for cuts.
How many 12 × 12 or 16 × 16 pavers for 100 sq ft?
About 98 pavers of 12 × 12 in and 56 of 16 × 16 in, with ⅛ in joints, before the extra.
How deep should the base be under pavers?
Belgard’s minimums, which it says match the Concrete Masonry & Hardscapes Association’s, are 4 in of compacted aggregate for patios and walks, 6 in for residential driveways and 8 in for parking areas and streets, under 1 in of bedding sand. Soft or wet ground and cold climates need more.
What sand goes under pavers?
Concrete sand (ASTM C33), screeded to a nominal 1 in and left loose until the pavers are compacted into it. Belgard says masonry sand, screenings and stone dust should never be used as the bedding layer.
Sources for the numbers on this page
- Belgard: Technical Resource Guide: paving systems installation (base 4 in for patios, 6 in for driveways; 1 in bedding sand; ⅛ in joints) · checked
- Vulcan Materials: Construction aggregates calculator: estimated density by rock and product (lb/ft³) · checked
- Quikrete: Building a concrete patio — project guide (2×4 forms, stakes at 3 ft, 4 in compacted gravel, ½ in isolation joint) · checked
Corrections and updates are logged on the sources page.