Guides

The reasoning behind the calculators — written to be checked, with every source linked.

Each calculator on ConcreteCounts gives you a number; these guides explain where that number comes from and what to do with it on the day. They cover the decisions the calculators can’t make for you: how thick a slab should be for its use, whether to buy bags or order a truck, how long to wait before loading new concrete, how far apart to set deck boards in summer or winter, and whether a fence on a slope should be stepped or racked.

Every guide works through real numbers, names the code section, manufacturer data sheet or industry body each figure comes from, and shows the date that source was last checked. If a figure has changed since, the sources page logs the correction.

Start with the job

Read the guide first if you are still deciding what to build; go straight to the calculator if you already know the dimensions.

Concrete

Start with how much concrete you need if you are pricing a pour: it walks through measuring, converting to cubic yards and adding overage, the same steps the slab and bag calculators take. The next three answer the questions that come after: whether the job is small enough for bags or big enough for a truck, how thick the slab should be for what will sit on it, and how long to keep people and cars off it while it cures. If you are pouring in hot, dry or windy weather, read how hot is too hot to pour with the evaporation rate calculator; if frost is forecast, read how cold is too cold to pour first. Before finishing, plan where the control joints go.

Decks

The deck guides cover two details that manufacturers’ instructions and the residential code spell out exactly: the gaps between boards and the stairs. The board-spacing guide sets out each manufacturer’s side, end and wall gaps by installation temperature, which the deck board calculator uses. The stair code guide lists the residential code limits for risers, treads, width, handrails and guards, with section numbers, and backs the stair stringer and baluster calculators.

Fences

A fence on level ground is mostly counting, which the fence calculator does. On a slope there is a choice to make first: step the panels down the hill or rack them to follow it. The guide explains how to measure the slope, how far each panel material can rack, and what to do about the triangular gaps under a stepped fence; the fence slope calculator works out the step or rack for each panel and the post heights for your run.

How to use these guides

Read a guide before you buy materials, not after. Each one lists the sources it relies on, so you can check a figure against the manufacturer’s current data sheet or your local code before you order. Where a guide and your building department disagree, the building department wins: local amendments to the residential code are common, and an inspector’s word is what gets a permit closed.

If something in a guide is wrong or out of date, the contact page explains what to send so it can be checked and corrected.